Lamination Pro video

Discussion in 'Segmented Turnings Forum' started by grossl, Apr 14, 2019.

  1. grossl

    grossl New Member

    I couldn't find a forum just for Lamination Pro and where, so I decided to post my question here. Please move it if it needs to be somewhere else.
    I just wonder if there is a video of someone making a 2nd generation lamination. I have seen the videos of using the software, but I would like to see someone actually putting it to use. In particular, I can't figure how to make the 2nd generation cuts accurate enough for them to be cut in the same place on the declining slope.

    Thanks
    Ron Grossl
     
  2. mfisher

    mfisher Super Moderator Staff Member

    Last edited: Apr 14, 2019
  3. grossl

    grossl New Member

    Thanks so much, Mike. Its not a video, but that PDF of Tips and Tricks pretty well explains what I wanted to know. It wasn't exactly where I thought it would be, but now I have found it, thanks to you.

    It does help, thanks
    Ron
     
  4. mfisher

    mfisher Super Moderator Staff Member

    Your welcome.
    Hopefully Lloyd will add to this.
     

Share This Page