• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
  • Due to a scam attack, the gallery is temporarily turned off. I am working to get this fixed but I have some other things that are higher prioriity. I do hope to have it back soon and there shouldn't be any changes to the content. At least, that is the hope.

Suggestion: On printout, show how much laminate to make

S

Scott Gordon

PRO Member
On the printout generated by Lamination Pro, it would be nice to have a table printed that said for X repeating units, start with Y-inches of laminate. The table would have various values for X. The woodworker could extrapolate in between as needed. I know this information shows on the screen when using the software, but if you didn't remember what it said, you have to go back into the software when you're ready to produce the design.
 
You must log in or register to reply here.
Back
Top