• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Finishing

Richard Bruce

PRO Member
I have noticed on several gallery posts that the finish on the projects is mirror like in it's reflection. So my question is what are the favorite types of finish used and how are they applied? I know a good clean surface and smooth surface is needed, but I can get the finish I'm looking for. Thanks in advance to all who reply.
 
I have noticed on several gallery posts that the finish on the projects is mirror like in it's reflection. So my question is what are the favorite types of finish used and how are they applied? I know a good clean surface and smooth surface is needed, but I can get the finish I'm looking for. Thanks in advance to all who reply.
When I want a shiny finish, I do this:
1. Sand through 320 grit.
2. Brush on lacquer sanding sealer and dry overnight.
3. Sand through 600 grit.
4. Spray on two coats of lacquer, waiting an hour between coats.
5. After drying at least several hours, smooth it off with #0000 steel wool.
6. Repeat steps 4 and 5 four more times, for a total of 10 coats.
7. After letting it dry for several days, buff with Bon Ami or Barkeepers Friend.

You end up with a finish like on the red piece to the left. It's a lot more work than slathering on some urethane but I think it looks better.
 
When I want a shiny finish, I do this:
1. Sand through 320 grit.
2. Brush on lacquer sanding sealer and dry overnight.
3. Sand through 600 grit.
4. Spray on two coats of lacquer, waiting an hour between coats.
5. After drying at least several hours, smooth it off with #0000 steel wool.
6. Repeat steps 4 and 5 four more times, for a total of 10 coats.
7. After letting it dry for several days, buff with Bon Ami or Barkeepers Friend.

You end up with a finish like on the red piece to the left. It's a lot more work than slathering on some urethane but I think it looks better.
Thanks for the help. I will give it a try.
 
Back
Top