updating WTP software

Discussion in 'Woodturner PRO Support Forum' started by Michael Wenman, Jul 11, 2018.

  1. Michael Wenman

    Michael Wenman PRO Member

    I have build 3.1.011 installed on my pc, I have downloaded and run the install for build 3.1.016, but after it says it is done, when I run WTP and click on Help > About, it still shows that I only have build 3.1.011 installed ???
     
  2. mfisher

    mfisher Super Moderator Staff Member

    Lloyd may have to step in and help. If you have your license agreement number, I would do a complete uninstall of WTP. Then download 3.1.016 again and run it. See if that fixes the problem. You may or may not be asked for the license number.

    I did check my WTP and when I pull up the help>about it has 3.1.016.
     
  3. Michael Wenman

    Michael Wenman PRO Member

  4. mfisher

    mfisher Super Moderator Staff Member

    Lloyd Johnson is the creator/programmer of the software. He also is the administrator of this web site.

    So did you do a complete uninstall, reboot your pc , download the program and reinstall?
     
  5. Michael Wenman

    Michael Wenman PRO Member

    I know that..was a Lloyd???? as hopefully for his response :)
     
  6. mfisher

    mfisher Super Moderator Staff Member

    My Bad.
     
    Michael Wenman likes this.

Share This Page