different size rows for open segment bowl

Discussion in 'Open-Segment Turnings Forum' started by Rod Smith, Apr 3, 2018.

  1. Rod Smith

    Rod Smith New Member

    I saw the following bowl on pinterest and thought it would be something different to try. I have the 18 segment open segment bowl plate. Would it be possible to design this with segment pro? I am thinking about using 9 segments in a row where you would leave every other segment blank on a row and then the next row would be the same and you could stagger them.

    I am sure that I could do this by hand row by row without a whole lot of difficulty but if Seg pro could do it that would be great.

    Rod
    [​IMG]
     
  2. mfisher

    mfisher Super Moderator Staff Member

    It would be feasible to design such a vessel in WTP (WoodTurner Pro). WTP allows for you to individually adjust each rows thickness. SP does not. In SP when you adjust the row thickness, it applies the same thickness and then adjusts the number of rows to fit the height of the vessel.
     
  3. Bob Beaupre

    Bob Beaupre Administrator Staff Member

    Mike is correct Segment Pro No, Woodturner Pro Yes
     

Share This Page