• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Lamination Pro Print Question

F

Frank Smith

Guest
When printing from Lamination Pro why doesn't the printout contain the information at the bottom of the screen (Board width, Repeating unit, Laminate needed)?
 
While I don't use Lamination Pro that much I just did a quick 1st gen board to make chevrons.

The information is pretty much there in the print screen, except material needed. The Print screen gives the measurement of each strip (if you totaled them it would give you the board width). It does give instruction on how to cut the first gen and the width of the repeating unit.

When I have used LP, I just made a note of how much material I needed in the laminated board.
 

Attachments

  • Clipboard01.jpg
    Clipboard01.jpg
    35.6 KB · Views: 8
Yes I agree that most of the information is there except the total length needed. That should be an easy add for a future release.

Edit: Thanks for the reply mfisher!
 
Last edited by a moderator:
At one time, it used to be there and I'm not sure what I did to break that. I'll get it added back for my next release.
 
At one time, it used to be there and I'm not sure what I did to break that. I'll get it added back for my next release.

Thanks Lloyd! Don't you hate it when that happens. I write software too and it happens all the time.
 
Back
Top