Outside Open Space

Discussion in 'Segment PRO Forum' started by Loy Jenkins, Dec 12, 2017.

  1. Loy Jenkins

    Loy Jenkins PRO Member

    In Segment Pro, is there any way to change the "Outside Open Space"? Mine is set at 1/8 inch. I would like more. Thanks in advance.
     
  2. Bob Beaupre

    Bob Beaupre Administrator Staff Member

    Can you explain a little better what you are looking for. Are you talking about the open segment space in a open segment bowl, or something else?
     
  3. Loy Jenkins

    Loy Jenkins PRO Member

    I am talking about the space between the segments. I am new to this and I thing I put my question in the wrong section. I am talking about 'Woodturner Pro'.
     
  4. Bob Beaupre

    Bob Beaupre Administrator Staff Member

    No problem. In Woodturner PRO to change the open segment gap, right below the profile snap in the upper right hand corner is the open segment degrees
     
  5. Loy Jenkins

    Loy Jenkins PRO Member

    Wow, that was easy. Thank you very much.
     
  6. Bob Beaupre

    Bob Beaupre Administrator Staff Member

    It's easy IF you know where it is
     

Share This Page