• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Open Segment Project "Interwoven"

Row 26 is now on. The colour has stopped, the next row is a segmented maple only row and that will be followed with a closed segment walnut row.

IMG_2604.JPG IMG_2603.JPG

1801 pieces now, 144 to go.
 
Row 28 is now complete. To do the closed segment on my Driskell jig I had to adjust my reference plate a little bit to enable the stop to be in the centre of the segments. Very minor issue. From there the segments seemed to flow around for the most part. I did make an adjustment to the SEL at one point as the segments were slightly running off the centre of the adjacent segment.

IMG_2607.JPG IMG_2608.JPG IMG_2609.JPG

I will probably wait until tomorrow for the glue to completely dry before I put it back on the lathe for final turning.
 
What a wonderful piece. I like your tip on using the jib for closed segment ring.
 
You made that look way too easy! :)

Remember how hard it was getting started with you closed segment bowl with the thin rows?

That fixture is worth it's weight in gold.

Nice job, looks really good
 
You made that look way too easy! :)

Remember how hard it was getting started with you closed segment bowl with the thin rows?

That fixture is worth it's weight in gold.

Nice job, looks really good

Thanks Bob. The Jig certainly made everything a lot easier. Hopefully the turning will go just as well.
 
Back
Top