Multiple ring wheel

mcjayjay

New Member
I have created a bowl with 3 rings all created using wheel ring type.

Row 2 - maple with walnut vertical spacers (spokes)
Row 4 - maple with walnut vertical spacers (spokes)
Row 3 - Tried to create walnut with maple vertical spacers (spokes)
Row 3 is the problem when I set it up as such it will not properly appear - please see attached image1 before selecting vertical spacer - please see image2 after selecting vertical spacer. What am I doing wrong?


 

stuart johnson

Super Moderator
Staff member
I don't think you are doing anything wrong. I just replicated the issue so hopefully Lloyd will check in and let us know it there have been any changes.
 

Bob Beaupre

Administrator
Staff member
mcjayjay, I get the same results using flat or wheel, it's going to have to be something Lloyd checks out in the program itself.
 

mfisher

Super Moderator
Staff member
I just did a quick test. From what I see WTP only allows you to choice one type of wood species for spacers. That species is used on all rings that you have spacers.

It looks pretty much the same in SP. one species for the spacers.
 
Last edited:

Lloyd Johnson

Administrator
Staff member
The reason that the Vertical Spacer field is on the right is where the properties for the Project are located. Woodturner PRO had become so full of fields that were almost never used, I chose to make some things work at the Project level, not the Row level and Vertical Spacers is one of them.

Lloyd
 

mfisher

Super Moderator
Staff member
In the few times I used different wood for spacers, it was pretty easy to calculate how much material I needed for the rings. It was no big deal that WTP did not show the change on the screen. WTP and SP are still the best segment planning software out today.
 
Top