• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. T

    User Preferences for Stave Slope confused

    Thanks for your reply. Definitely helps understanding the difference between staves and Compound segments. Now for the next questions. Currently I would like to make a ring with a 4" base (lower diameter) and 10" upper diameter and about a 40 degree slope. The board I will be using is 5.25"...
  2. T

    User Preferences for Stave Slope confused

    I'm not really sure but can someone explain the setting for slope in User Preferences in reference to where the angle is measured. Is >0 the angle from a horizontal plane to the outside edge of the stave? Is the <90 measured from a 90 degree vertical to the slope. If this is correct, then...
  3. T

    Cannot do different size segments on the same ring?

    Ahh! Like usual I make things so much more difficult than the easy answer.. Thanks
  4. T

    Cannot do different size segments on the same ring?

    I think I got it. Here is a screen print.
  5. Using Open Segments for feature Ring

    Using Open Segments for feature Ring

    Open segment degree set to 22 or 14 (must use two plans) and use segments to fill in the open segment for a zig zag type pattern.
    • Ted Kline
    • Media item
    • Comments: 1
    • Category: Segmented Turnings
  6. T

    Cannot do different size segments on the same ring?

    The spacer option does not build a segment here is a view of the bowl I've not yet assigned wood species but you should get the idea.. I'm using open segment degree at 22 and 14, but why does it revert to 4 degrees after it was saved at 22 when it is opened? Here is a screen shot Opps.. how...
  7. T

    Cannot do different size segments on the same ring?

    I'm trying to design a somewhat simple pattern with a 20 piece ring 10 segments larger with 10 smaller segments, then the next ring would be the same but could offset so the rings result in what I would call a blocked zig zag pattern. I can get close with open segments using the open spaces as...
  8. T

    Printing problems

    I have experienced the same printing problems but found the solution to be adjusting the display resolution. Using a new laptop with high resolutions for example my laptop recommends using 1920 x 1024. When I reduce the resolution to 1600 x 900 the print preview and printing comes out...
Back
Top