• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. T

    bird design

    Lloyd; would you be adding more samples in lamination pro? Thanks
  2. T

    bird design

    Thanks Glenn. I am going to keep your post as a resource. Was trying to put it on my desktop but couldn't figure out to do it. Have you made your own designs other than the ones furnished by Lloyd in lamination pro? 2nd, I see where you calculated a 7" radius to trim the inside and outside of...
  3. T

    bird design

    Also, I understand now, with the birds wingspan that one could only go so small before you lost detail of the design. I have a lathe with a 14" swing, would that be sufficient to do a bird feature ring? My brother just made a bowl with the bird design, looks awesome. I will start out with a more...
  4. T

    bird design

    Lloyd I had two questions. I was looking for the post from the gentleman that had photos of the steps used in making the bird design. 2nd after you have glued up the segments in the feature ring, are there any hints as to reducing the thickness of the ring? Thanks Tom.
  5. T

    bird design

    Thanks Lloyd. I never thought of the thickness. If it is 1.5", does that mean you will waste a lot of wood, or will the image be different on the inside of the bowl as opposed to the outside? You mentioned any less than 10 segments, one couldn't turn it. Was that because of the segment width? I...
  6. T

    bird design

    I can help you size the laminated board to end up with an up-facing eagle if you let me know how big of a bowl you want to make. My bowl that appears on the front page of the home page was 10" in diameter. If that size works for you, I can make you a Lamination PRO file that will duplicate that...
  7. T

    bird design

    Bob: very nice bowl. Thanks for the video. Thanks Tom.
  8. T

    bird design

    Bob: Thanks for the reply. I was hoping to design different feature rings using lamination pro, not relying on just the samples. I would like to start out with a design concept and attempt to make a feature ring using lamination pro, but there doesn't appear to be an import function. For example...
  9. T

    bird design

    Thanks very much Lloyd. I just downloaded it. It looks more like your videos. I will start looking through it. Again, any assistance you can provide making the bird lamination for an 8" bowl would sure help. thanks Tom
  10. T

    bird design

    Lloyd: thanks for the info. I would like to do a slightly smaller bowl, say 8". could you help me design a lamination. Also, is there a way I can make my own designs, using lamination pro and importing species. My brother Jack has your program too and has made the bird ring. My lathe swing is...
  11. T

    bird design

    Lloyd: Thanks for the info. If i read correctly, Glenn made the lamination with the eagle facing on their sides, but then cut them apart to flip them so they were facing up? He would then have to cut them into segments to glue into rings? I might be wrong on that, but it sounds like that is what...
  12. T

    bird design

    This may have already been addressed in other posts. I would like to rotate the bird design 90 degrees in lamination pro so that the design faces up. I have looked at the sketch-up video, but it doesn't advise how to import it into lamination pro. Plus I can't seem to get a handle on to how to...
Back
Top