• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. Andrew Rothwell

    Dried glue clean up

    Well, I figured I would chime in with my findings. 1st, heart gun and scraper, works, though it kind of just smears the glue off. 2nd, and what I did, was a pot of water and about 10 % vinegar. Put the clamps in, and boil away for a few minutes, take a clamp out, and then scrape with a scraper...
  2. Andrew Rothwell

    Dried glue clean up

    My go to glue is TB 3, with the longer working times, I find it more forgiving when gluing a lot of segments. I will try the heat gun trick and report back. Thank you.
  3. Andrew Rothwell

    Dried glue clean up

    Greetings, How do you folks handle the dried glue squeeze out that remains on the clamps after the ring is dry? Thank you, Andrew
  4. Andrew Rothwell

    Weird Results

    Good Morning - So I went back and re-watched the video - and then cut another test ring - and it was perfect. It was definitely an ID10T error. I was marking all my pieces, but I was flipping them, instead of arranging them with the marking up. I guess that was compounding any error that I had...
  5. Andrew Rothwell

    Weird Results

    There is definitely 2 fences, I was just testing the angle of the wedge. I'll try to get another ring tomorrow. And yes, I am using both of the fences.
  6. Andrew Rothwell

    Weird Results

    So here's another pic
  7. Andrew Rothwell

    Weird Results

    Here's the image And the wedgie set that I bought was the wedgie set 3 Wedgie Set 3 contains one each: 16, 18, 20, 24, 32, 36, 40, 48
  8. Andrew Rothwell

    Weird Results

    Thus the compounded angle of the segment is 11.25 Semantics - Still does not help with why it's coming out at a 30 segment ring instead of the 32 that it should be.
  9. Andrew Rothwell

    Weird Results

    Greetings all - Not sure which forum to post this in - so it's going here. I am using a wedgie sled, based on Lloyds Design, and using the 32 segment wedgie that I bought from him too. However when I cut 32 segments there is a HUGE discrepancy in the ring. However if I take 2 segments out -...
  10. Andrew Rothwell

    Frequently Asked Questions about Segment PRO

    Fair Enough - Thanks for the quick response. I only ask because the answer is ALWAYS no, unless you ask :) Thanks again
  11. Andrew Rothwell

    Frequently Asked Questions about Segment PRO

    Great looking software Lloyd. Are you going to be allowing those of us that have the Full suite and upgrade price to get segment pro? Thank you Andrew
  12. Andrew Rothwell

    Table Saw Sled for Open Segment Vessels

    Hi, the pdf seems to be broken. I am able to download it, but it will not open. I have other pdf files that do open just fine. Do you happen to have a another link somewhere else? Thanks
Back
Top