Recent Activity

Activity stream for all registered members at Woodturner PRO.

  1. Brent Dalrymple liked Jan Conradie's media Celtic Knot Flask in the category Segmented Turnings

    The flask is 292 mm high and 105 mm wide. It is made of African White Pear and Imbuia.

    P1010225 a.jpg Jul 22, 2017 at 10:34 AM
  2. Lloyd Johnson replied to the thread resolution issue on laptop.

    I'm always glad to help a customer, Dave. :-> Fortunately, prices are quite reasonable for PCs, including laptops, these days.

    Jul 21, 2017 at 3:08 PM
  3. davehu replied to the thread resolution issue on laptop.

    Thanks for the reply. I figured as much. to be fair, my laptop is 7 years old and maybe this is the excuse I needed to buy a new...

    Jul 21, 2017 at 1:04 PM
  4. Jan Conradie added new media Celtic Knot Flask to Segmented Turnings

    The flask is 292 mm high and 105 mm wide. It is made of African White Pear and Imbuia.

    P1010225 a.jpg Jul 21, 2017 at 12:55 AM
  5. Lloyd Johnson replied to the thread Changing to Metric.

    I'm not sure where you are getting 'metric inches' which everyone knows is an oxymoron. Since 90% of my customers use inches, I store...

    Jul 20, 2017 at 9:38 PM
  6. Lloyd Johnson replied to the thread resolution issue on laptop.

    Dave, When writing an user interface, you have to pick a number of lines of resolution to target. If I were to pick 768 (the resolution...

    Jul 20, 2017 at 8:59 PM
  7. jbuck57 replied to the thread Changing to Metric.

    I would suggest that all measurements should be fully in the metric system, ie millimeters / centimeters etc as is the case in most...

    Jul 20, 2017 at 5:35 PM
  8. FredGriffiths replied to the thread New to WoodTurnerPro.

    Hi Lloyd, thank you greatly for your lengthy explanation. And for explaining the inclusion of SegmentPro - I re-read the email but...

    Jul 20, 2017 at 5:07 PM
  9. davehu posted a new thread.

    resolution issue on laptop

    ok, been testing Segment Pro with my desktop computer. going along fine. Next month I am planning on doing a review for our turners...

    upload_2017-7-20_18-24-14.png upload_2017-7-20_18-27-19.png

    Forum: Bug Reports and Feedback

    Jul 20, 2017 at 4:27 PM
  10. Lloyd Johnson replied to the thread New to WoodTurnerPro.

    Fred, There was also a purchasing option to buy one-on-one training from me for a minimum of an hour for $40. If you are new to...

    Jul 20, 2017 at 3:40 PM
  11. Lloyd Johnson replied to the thread New to WoodTurnerPro.

    Fred, I removed the grid a long time ago and here are the reasons - first, it added almost no value. Bowls aren't typically made with...

    Jul 20, 2017 at 3:21 PM
  12. FredGriffiths replied to the thread New to WoodTurnerPro.

    Thankyou Mfisher, When I open 3Dpro, the first little box shows Ver3.1.9, but when I look under the Help>About menu it says 3.1.0.0. So...

    Jul 20, 2017 at 3:17 PM
Loading...