F
FredGriffiths
Guest
Hello
I had done some wood turning many years ago, and taken up segmented turning about a year ago. I have had good success using the old fashioned paper and pencil method of planning. But now I have the computer version!
However, I am still struggling to learn the programs 3D Design, Woodturner and Lamination. I’m at a disadvantage in that my wife bought this 3 piece suite as a birthday present 2 weeks ago and I had not even used the 30 day trial period to see how it would work.
I had asked, in reply to the original welcoming email, why my version of 3D Design does not have the grid, but rather a hand (which is greyed out and non functioning) different than shown in the tutorials. I have not received a reply. I realize you are busy with everything, but you did say to contact you if I have questions. A second email to the same address is also unanswered - so perhaps I had been sending to the wrong address.
I notice quite some differences between my programs and those shown in the tutorials. I won’t try to enumerate details at this time. I fail to see how Lamination Pro is used to make feature rings in segmented bowls. It appears my wife should have bought SegmentPro instead. Is this a correct assumption? As it was, the 3 piece suite was quite expensive, without the SegmentPro.
I had done some wood turning many years ago, and taken up segmented turning about a year ago. I have had good success using the old fashioned paper and pencil method of planning. But now I have the computer version!
However, I am still struggling to learn the programs 3D Design, Woodturner and Lamination. I’m at a disadvantage in that my wife bought this 3 piece suite as a birthday present 2 weeks ago and I had not even used the 30 day trial period to see how it would work.
I had asked, in reply to the original welcoming email, why my version of 3D Design does not have the grid, but rather a hand (which is greyed out and non functioning) different than shown in the tutorials. I have not received a reply. I realize you are busy with everything, but you did say to contact you if I have questions. A second email to the same address is also unanswered - so perhaps I had been sending to the wrong address.
I notice quite some differences between my programs and those shown in the tutorials. I won’t try to enumerate details at this time. I fail to see how Lamination Pro is used to make feature rings in segmented bowls. It appears my wife should have bought SegmentPro instead. Is this a correct assumption? As it was, the 3 piece suite was quite expensive, without the SegmentPro.