• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Recent content by Tom Dlugosh

  1. T

    Open Segment Project - Maze

    Beautiful work Bob!
  2. T

    Open Segment Project - Maze

    good save!
  3. T

    Patriot

    If you ever do try to make this piece, consider making segments that are half maple and half blue or red or white etc. to straighten the vertical lines. With 144 piece segments this should be a piece of cake. HA!
  4. T

    Closed Segment Project 1441

    Glenn, I did a vessel that was almost all wenge and it took 12 coats of poly (2 coats of sanding sealer, 9 coats of gloss and 1 coat of satin.) When I finished there were no pores visible. This technique is a variation of one that I learned from Malcom Tibbetts. Generally, on most close grain...
  5. T

    Collaborative Bowl Project - Closed Segment

    I agree with Stuart Johnson, you went to a lot of work for a so so result. It seems that you are not completely satisfied with your effort. If you want to learn this process I'd start again and strive to get the outer edges aligned perfectly which will go along way in making the ring round...
  6. T

    Collaborative Bowl Project - Closed Segment

    In your picture of the glue up it looks like the outer edges are not aligned with each other. This may be part of your problem especially since you split the glue up and flipped the resulting pieces.
  7. T

    stomper

    I use a removable plug in the plastic plunger that has a sharpened screw in the center. I can remove it and use a longer dowel turned for a snug fit into the plunger for longer length or I turn some items in halves where appropriate. The sharpened screw center allows me to turn a small dimple...
  8. T

    Video Tutorial: 3-part tutorial on creating a Stacked Wood feature ring in Woodturner

    The widget column on the right side of the screen blocks part of the tutorial. How can I get rid of it?
Back
Top