Recent content by Bob Griffin

  1. B

    Hi, a note to Lloyd that I just finished my Eagle vessel and am happy that it is finished.

    Hi, a note to Lloyd that I just finished my Eagle vessel and am happy that it is finished.
  2. B

    bob g

    hey, I just saw a post about my question that answered it. thanks
  3. B

    bob g

    using WTP I want to add vertical veneer strips between the segments of a flat segment ring. I haven't seen where there is a resize tool, that would allow dimensioning of the veneer strips in the menu. I see the veneer ring tool in the menu, but it refers to horizontal ring setups. I have used...
  4. B

    bob g

    man! ya'll are great with the info. Now I get to practice what you taught me! ! ! thanks so much. BG
  5. B

    bob g

    Yes that's allcorrect. When I set the bowl width first, I then start adding rings to theproject. If I add enough rings to get the height I need, the rings will behigher than the bowl wall profile that's transferred from 3D Design pro. When I tried to snap to profile, the bottom most rings...
  6. B

    bob g

    hi, just starting with WTP. i set the width and height for my project bowl and add the rings. after setting up the ring data, WTP changes the width of my bowl. i do not want to change this. what did i not do correctly? help needed please?
Top