Jeff Miller's Recent Activity

  1. Jeff Miller replied to the thread Still having issues with cutting consistent thin strips on table saw.

    I would check the angle on the board after taking one segment off. For instance, if the angle is exactly 45 degrees, the board should...

    Jul 17, 2019 at 6:33 PM
  2. Jeff Miller replied to the thread Still having issues with cutting consistent thin strips on table saw.

    I believe the board width will greatly depend on how accurate the angle is when cut. The software showed a cut width of 7/8", so the...

    Jul 17, 2019 at 5:51 PM